Assembl – United States Stove Company 1537M User Manual

Page 10

ASSEMBL

ASSEMBLY OF FURNA

Y OF FURNA

Y OF FURNACE

Your furnace requires the following items
to be assembled or installed by the service
person:

Feed Door Pull Handle
Feed Door Locking Handle
Blower(s) and Blower Controls
Electrical Connections

Remove all parts from inside the furnace
and inspect for damage, including the
firebrick as some breakage could occur
during shipment.
Assemble the feed door pull handle as
shown in Figure 8.
Attach feed door locking handle as in
Figure 9 with screws and nuts provided.
Note: Slotted holes are for adjustment of
handle. Adjust handle until some pres-
sure is required to lock feed door during
firing sequence.
Install Honeywell Fan/Limit Control on
rear of furnace cabinet as shown in Fig-
ure 10.
Remove blower(s) from carton(s). Re-
move junction box cover. Attach clip nuts
as in Figure 10. Install blower(s) and
gasket(s) with 1/4"-20x3/4" bolts as
shown.
Wire right side blower first (See wiring
diagram, Fig. 11) and replace cover on
junction box on blower.
Wire left blower same as above and re-
place cover.
Check operation of shaker grates with
grate handle before operating furnace.

Honeywell
FAN/LIMIT
CONTROL

4" ELECTRICAL
JUNCTION BOX

BLOWER
ASSEMBLY

GASKET

CLIP NUTS
(DO NOT USE CLIP NUT
ON UPPER CENTER HOLE)

Fig. 10

Fig. 9

Fig. 8

(MODEL 1537M- 2 BLOWERS)

Factory

Installed