Cleaning the mask between patients, Caution – ResMed ULTRAMIRAGE 608140/20611 User Manual
Page 9

5
En
gli
sh
CAUTION
•
Do not use bleach, chlorine, alcohol, or aromatic-based solutions,
moisturizing or antibacterial soaps, or scented oils to clean any of the mask
components. These solutions may cause damage and reduce the life of the
product.
•
Do not expose any part of the mask system or tubing to direct sunlight as it
may cause the product to deteriorate.
•
The headgear is sensitive to heat and must not be ironed.
•
If any visible deterioration of a mask component is apparent (cracking,
crazing, tears, etc), the mask component should be discarded and replaced.
Cleaning the Mask between Patients
All mask components can be disinfected/sterilized using validated procedures.
The following table presents a summary of the validated procedures for
disinfection/sterilization of the system. Refer to the website
www.resmed.com/masks/sterilization/americas for details.
To clean the headgear between patients use the method described in the
previous section “Cleaning the Mask in the Home”.
Methods
Pre-disinfection/
sterilization
Disinfection/Sterilization
Chemical
Detergent
eg, Alconox
™
Solution (any one)
•
Ortho-phthalaldehyde 0.55% (eg, CIDEX
™
OPA)
•
Glutaraldehyde 3.4% (eg, CIDEX Plus
™
)
Thermal
Detergent
eg, Alconox
Temperature-time (any one)
•
158°F (70°C) for 100 minutes
•
167°F (75°C)for 30 minutes
•
176°F (80°C) for 10 minutes
•
194°F (90°C) for 1 minute
STERRAD
™
Detergent
eg, Alconox
System
STERRAD Sterilization System
Notes:
•
Testing by ResMed has shown that the components can withstand 15 cycles of
disinfection/sterilization for the methods listed in the table.
•
When using detergents, disinfectants or sterilization agents, always follow the
manufacturer’s instructions.
608140r2.book Page 5 Thursday, November 2, 2006 9:37 AM