RocketFish RF-QX4 - Manual (Page 8)

8 RF-QX4/RF-QX4-T/RF-QX4-E/RF-QX4-J
5 Activate the Bluetooth connection from the phone. See the
documentation that came with the phone for instructions.
6 Set the phone to start searching for Bluetooth devices.
7 Select RF-QX4 from the list of found devices displayed on the
phone.
8 If necessary, enter the PIN code 0000 to pair and connect the
headset with your phone. With some phones, you need to make a
connection separately after pairing.
Disconnecting the headset from the phone
To disconnect the headset from the phone:
• Turn off the headset.
Or,
• Disconnect the headset in the phone’s menu.
Or,
• Move the headset more than 33 feet (10 meters) away from the
phone.
Note: You do not need to delete the pairing with the headset to disconnect the
headset. When you reconnect the headset to a phone it has been paired with, you do
not have to enter the code 0000 again.
Reconnecting the headset to the phone
Note: The headset connects to the last connected phone by default. If the last phone is
out of the Bluetooth operating range or you are not using the last phone, the headset
searches and connects to the other paired phones.
To reconnect the headset to the last phone used:
• If the headset is turned off, turn it on. It automatically connects to
the phone.
Note: If the headset is out of Bluetooth operating range (33 feet/10 meters), the
headset sounds a warning tone. If you move the headset back into operating range
within two minutes, it automatically reconnects with the phone.
If the headset is out of Bluetooth operating range for more than two minutes, go
back into range then press and hold the Power/Send/End button until a beep sounds to
indicate the connection is reactivated.
Making a call
To make a call:
• Use the phone in the normal way. See the phone’s documentation
for instructions.