beautypg.com

Setting up, Charging battery pack ey9251 – Panasonic EY3551 User Manual

Page 8

background image

- 8 -

tery pack with a cloth, etc., while charging.

22) Use of an attachment not recommended

may result in a risk of fire, electric shock,

or personal injury.

23) Do not short the battery pack. A battery

short can cause a large current flow, over

heating and create the risk of fire or per-

sonal injury.

24) NOTE: If the supply cord of this appliance

is damaged, it must only be replaced by a

repair shop authorized by the manufacturer,

because special purpose tools are required.

25) TO REDUCE THE RISK OF ELECTRIC

SHOCK, THIS APPLIANCE HAS A POLAR-

IZED PLUG (ONE BLADE IS WIDER THAN

THE OTHER).

This plug will fit in a polarized outlet only

one way. If the plug does not fit fully in the

outlet, reverse the plug. If it still does not

fit, contact a qualified electrician to install

the proper outlet.
Do not change the plug in any way.

III

. SETTING UP

Charging Battery Pack EY9251

Charge the battery pack when the cutting speed
becomes too slow for effective cutting.
If you have two battery packs, you can use one to
continue working while charging the other one.
NOTE:
When you charge the battery pack for the first
time, or after prolonged storage, charge it for
about 24 hours to bring the battery up to full
capacity.
Battery charger (EY0110)
1. Plug the charger into the AC outlet.

NOTE:
Sparks may be produced when the plug is
inserted into the AC power supply, but this is
not a problem in terms of safety.

2. Insert the battery pack firmly into the charger.

Battery
pack

To AC
outlet

Battery
charger

1

2

3. During charging, the charging lamp will be lit.

When charging is completed, an internal elec-
tronic switch will automatically be triggered to
prevent overcharging.
• Charging will not start if the battery pack

is warm (for example, immediately after
heavy-duty operation).
The orange standby lamp will be lit until the
battery cools down. Charging will then begin
automatically.

4. When charging is completed, the charging

lamp will start flashing quickly in green color.

5. When in any of the conditions that battery

pack is too cool, or the battery pack has not
been used for a long time, the charging lamp
is lit. In this case, charging takes longer to fully
charge the battery pack, than the standard
charging time.
• If a fully charged battery pack is inserted

into the charger again, the charging lamp
lights up. After several minutes, the charg-
ing lamp may flash quickly to indicate the
charging is completed.

6. If the charging lamp does not light immediately

after the charger is plugged in, or if after the
standard charging time the lamp does not go
off, consult an authorized dealer.
NOTE:
• When charging a cool battery pack (below 5°C

(41°F)) in a warm place, leave the battery pack
at the place and wait for more than one hour to
warm up the battery to the level of the ambient
temperature. Otherwise battery pack may not
be fully charged.

• Cool down the charger when charging more

than two battery packs consecutively.

• Do not insert your fingers into contact hole,

when holding charger or any other occasions.

CAUTION:
To prevent damage or risk of fire:
• Do not use power source from an engine gen-

erator.

• Do not cover vent holes on the charger and the

battery pack.

• Unplug the charger when not in use.