Pioneer KEH-P6020RB - Manual (Page 29)

07
Section
Audio Adjustments
En 29
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Setting the sound focus equalizer
Clarifying the sound image of vocals and instru-
ments allows the simple staging of a natural,
pleasant sound environment.
Even greater listening enjoyment will be
obtained if seating positions are chosen care-
fully.
•
FRT1 boosts the treble on the front output and
the bass on the rear output.
FRT2 boosts the treble and the bass on the front
output and the bass on the rear output. (The
bass boost is the same for both front and rear.)
For both
FRT1 and FRT2 the HI setting provides
a more pronounced effect than the LOW setting.
1 Press SFEQ to select the desired SFEQ
mode.
Press
SFEQ repeatedly to switch between the
following setting:
FRT1-HI (front 1-high)— FRT1-LOW (front 1-
low)— FRT2-HI (front 2-high)— FRT2-LOW (front
2-low)— CUSTOM (custom)— SFEQ OFF (off)
Selected mode (e.g., F1 ) appears in the display.
2 Press
2 or 3 to select the desired position.
Press
2 or 3 until the desired position appears
in the display.
L (left)— C (center)— R (right)
Note
• If you adjust the bass or treble, CUSTOM
memorizes an SFEQ mode in which the bass
and treble are adjusted for personal prefer-
ence.
Using balance adjustment
You can select a fader/balance setting that pro-
vides an ideal listening environment in all occu-
pied seats.
1 Press AUDIO to select FADER .
Press AUDIO until FADER appears in the dis-
play.
• If the balance setting has been previously
adjusted,
BAL will be displayed.
2 Press
5 or ∞ to adjust front/rear speaker
balance.
Each press of
5 or ∞ moves the front/rear
speaker balance towards the front or the rear.
•
FADER :F15 – FADER :R15 is displayed as the
front/rear speaker balance moves from front to
rear.
•
FADER : 0 is the proper setting when only two
speakers are used.
• When the rear output setting is subwoofer,
you cannot adjust front/rear speaker balance.
Refer to Switching the rear output setting on
page 36.
3 Press
2 or 3 to adjust left/right speaker
balance.
When you press
2 or 3,
BAL : 0 is displayed.
Each press of
2 or 3 moves the left/right
speaker balance towards the left or the right.
•
BAL :L9 – BAL :R9 is displayed as the left/right
speaker balance moves from left to right.