POSIFLEX Business Machines 16560900020 - Manual (Page 11)

Part 11
window are designated for VGA port and COM port
power supply function. Please consult your dealer for
technical support on setup of these jumpers. Please
note that only those qualified technicians
may adjust in the service
window with information from
Posiflex and the contents in the
service window may change
without notice as time develops.
SIDE MOUNT UPGRADE KIT (OPTION)
Remove the 2 screws circled in last picture above
to remove the cover for side mount upgrade kit. Take out
the cable inside this cover and connect it to connector
inside the side mount upgrade kit like SD400T as circled
in the right picture. Gently arrange the excessive length of
this cable back in the hole and screw-fit it back to the
position originally occupied by the cover. Please reserve
the cover if there is chance to have the side mount kit removed in the future.
REAR TOP MOUNT UPGRADE KIT (OPTION)
To mount the rear top mount upgrade kit
like PD-310 or PD-2604 on the back of KS series,
please apply carefully the 2 small fixation shoulder
screws that come along with PD-310 or PD-2604
to the back of KS series at the screw hole triangle
marked in the right picture. However please do not
screw them to the bottom but at a position that is
about 1 turn loose from the bottom. Similarly please loosen the screws by 1
turn for some models with these 2 screws preinstalled. Arrange the interface
cable of the rear top mount upgrade kit to go into the first groove to the right
of the left shoulder screw on back of main unit as in the above right picture.
For gen 6 super slim base models, please stick the 2 attached cable clips at
arrowed positions in the picture for cable routing when later joining the main
unit to gen 6 base. Hook the rear bracket of the upgrade kit onto the shoulder
screws. Slide down the upgrade kit and gently tighten the shoulder screws. Do
not overdo the tightening or unrecoverable thread damage will occur.
Remember to enable the +5 V DC supply in the COM port of the main unit for
the upgrade kit if the serial interface model is used. The power supply in the
I/O port must be disabled if it is no longer to support these intended devices
otherwise any damage or loss caused consequently shall be out of product
warranty! However, if the customer display used is the USB interface model,
Service Window
Lock Screw
Jumpers