Panasonic SCAKX14 - Manual (Page 11)

9
USB
You can connect and play MP3 tracks from your USB
device.
Do not use a USB extension cable. The system cannot
recognize USB device connected through a cable.
1
Connect the USB device to the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2
Press [USB] and then press [4/9] to start playback.
For other operation, refer to “Disc”.
Compatible USB devices which are defined as mass
storage class:
• USB devices that support bulk-only transfer.
• USB devices that support USB 2.0 full speed.
Note:
• Files are defined as tracks and folders are defined as
albums.
• Track must have the extension “.mp3” or “.MP3”.
• This system can access up to:
– 255 albums (including albums without MP3 tracks)
– 2500 tracks
– 999 tracks in one album
• CBI (Control/Bulk/Interrupt) is not supported.
• NTFS file system is not supported (only FAT 12/16/32 file
system is supported).
• Some files can fail to work because of the sector size.
Radio
Manual tuning
1
Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN])
to select “FM” or “AM”.
2
Press [3] or [5] to select the frequency of the
required station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
Improving the sound quality
When “FM” is selected
1
Press [RADIO MENU] to select “FM MODE”.
2
Press [Y, U] to select “MONO” and then press [OK].
To cancel, select “STEREO”.
“MONO” is also canceled when you change the
frequency.
When “AM” is selected
1
Press [RADIO MENU] to select “B.PROOF”.
2
Press [Y, U] to select “BP 1” or “BP 2” and then
press [OK].
Memory presetting
30 FM and 15 AM stations can be preset.
Automatic presetting
1
Press [OK] to select “LOWEST” or “CURRENT”
frequency.
2
Press [AUTO PRESET] to start presetting.
To cancel, press [8].
Manual presetting
1
Press [3] or [5] to tune in to the station.
2
Press [PROGRAM].
3
Press the numeric buttons to select a preset
number.
Do steps 1 through 3 again to preset more stations.
The new station replaces any station that occupies the
same preset number.
Selecting a preset station
Press the numeric buttons, [2] or [6] (main unit:
[2/3] or [5/6]) to select the preset station.
FM allocation setting
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO/EXT-IN] to select “FM” or “AM”.
2
Press and hold [RADIO/EXT-IN].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps again.
• After you change the setting, preset frequencies are
erased.
Stop
playback Press [8] during playback.
“RESUME” is shown.
Press [4/9] to continue playback from the
start of the track.
OR
Press [8] two times to stop the playback fully.
AKX14P.En.book Page 9 Tuesday, January 31, 2012 2:46 PM