Panasonic SCHT56 - Manual (Page 14)

14
RQTX0175
Settings
Output the signal. Adjust the main
volume. Select the speaker
channel. Adjust the level. Stop the test
signal.
VOL
C +4dB
Press and hold.
Repeat for each speaker channel
C (center), RS (surround right) and LS (surround left) can be adjusted between -6 dB and
+6 dB, with 0 dB being the level of the front speakers. Adjust center and surround output to
the same apparent level of the front speakers.
For SUBW (subwoofer), you can select “SUBW OFF” so there is no output, “SUBW MIN”
for minimum output, a level between 1 and 19, or “SUBW MAX” for maximum output. Adjust
subwoofer output so it is balanced with the front speakers.
Press and hold.
L C R RS LS SUBW
TEST L
VOL
(A/D Attenuator)
Turn the A/D attenuator on if “OVERFLOW” lights frequently
when using 2-channel analog input. The factory setting is OFF. •
DRCOMP (Dynamic range compression)
Change this setting to listen to software recorded with Dolby
Digital at low volume (such as late at night) and maintain audio
clarity. It reduces the peak level in loud scenes without affecting
the sound field. •
OFF: The software is played with the original dynamic range (factory setting).
STANDARD: The level recommended by the producer of the software for household
viewing.
MAX: The maximum allowable compression (recommended for night viewing).
Attenuator
TV delay Delay audio if there appears to be a difference in timing between
audio and pictures. The factory setting is ON.
•
To reduce standby power consumption.
Choice for turning off the VIERA Link “HDAVI Control
TM ”
(➡ page 8).
•
• HDMI settings
Standby selection
OFF: Standby power consumption reduced
(approximately 0.3 W).
Signals from DVD equipment cannot pass
through HDMI connection to the television
when the unit is in standby (➡ page 8).
VIERA Link “HDAVI Control” (➡ page 8)
does not work when the unit is in standby.
ON: Normal standby power consumption
(factory setting)
•
•
VIERA Link “HDAVI Control”
OFF: VIERA Link “HDAVI Control”
is OFF
ON: VIERA Link “HDAVI Control”
is ON (factory setting)
HDMI STNBY
OFF
ON
CTRL
DRCOMP OFF
STANDARD
MAX
ATTENUATOR OFF
ON
TV DELAY OFF
ON
3 2a 2b
Adjusting speaker output level
Settings Display
Switch on.
SC-HT56P_MP (RQTX0175-2P).indb 14 9/19/2008 12:28:35 PM