Pioneer S-DV440 - Manual (Page 54)

Other connections 11
54
En
• When Recording mode is off, the audio
from the analog output may be interrupted,
depending on the operation.
• The Recording mode automatically
switches off if you change the input
function (
DVD/CD , TUNER , etc.) or switch
the power off.
Connecting using the S-video
output
If your TV has an S-video input, you can use this
instead of the standard video output for a
better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video
input on your TV.
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
Note
• The S-video output is switchable between
S1 and S2 formats for compatibility with all
TVs. See
Video Output settings on page 48
to change this setting.
Connecting using the
component video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV. This should
give you the best quality picture from the three
types of video output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT to a set of component inputs
on your TV.
Note
• The component video output is switchable
between interlaced and progressive
formats. See
Video Output settings on
page 48 for more on this.
About progressive scan video
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output.
AM
LOOP ANTENNA
FM
UNBAL 75 Ω
OPTICAL IN
IN
LINE 2
AUDIO
ANTENNA
CONTROL
VIDEO
OUT
S-VIDEO
OUT
VIDEO COMPONENT VIDEO OUT
P R P B Y
TV
XV–DV440/740
S-VIDEO
INPUT
FM
UNBAL 75 Ω
IN
ANTENNA
CONTROL
COMPONENT VIDEO OUT
P R P B Y
AM
LOOP ANTENNA
TV
XV–DV440/740
COMPONENT
INPUT
XV-DV323.book 54 ページ ２００４年２月１０日 火曜日 午後６時１０分