Philips Lighting HQ6640 - Manual (Page 11)

9
car testing and delivery –
quality and audit checks
This section of a car factory often appears like a
large maintenance and repair garage. Final exterior
and interior inspection are performed, cars are
fully tested (water tightness, wipers, lights, engine,
gearbox, final paint inspection etc.), and repairs
are made as necessary. Optionally, the cars are
coated with wax or surface-tempered plastic for
protection during transportation to the dealer.
Lighting recommendations
Illuminance General area: 500 lux
Specific inspection:
750 – 1,500 lux
Uniformity E min / E ave > 0.7
Luminance Limited, no bare lamps visible
High: simulating a showroom
Color temperature Neutral
Color rendering R a
≥
80
General lighting provides a basic uniform
illuminance on the total floor, while additional
task lighting facilitates car inspection.
Typical lighting installation
A typical arrangement is the use of waterproof
luminaires for wet areas and aluminium- or
glass / plastic- covered industrial reflectors
for general lighting.
A
U
T
OMO
TIVE INDUSTR
Y LIGHTING