Panasonic ES8017 User Manual

Page 4

Parts identification

(see fig. 1)
A Protective cap
B System outer foil
C System outer foil release buttons
D Foil frame
E Inner blades
F Foil frame release buttons
G On/Off switch
H Battery capacity lamp
I Charge status lamp
J Trimmer
K Trimmer handle
L Power cord
M Cleaning brush
N Travel pouch

Charging and cordless
shaving

(see fig. 2)
When charging the shaver for the first
time or when it has not been in use
for more than 6 months, charge it for
at least 8 hours before use.
Connect the power cord to the shaver
and plug the power cord to an AC
outlet.
It will adjust automatically to voltages
between 100-240V AC.
In some areas, a special plug adap-
tor may be required.
The charge status lamp will glow when
the shaver is being charged. It will
flash when the charging is completed.
You can fully charge the shaver in 1

hour if the battery capacity lamp blinks
in red. The battery capacity lamp will
glow in three colors depending on its
charge capacity level:
100% - 30% : green
30% - 10%

: orange

less than 10% : blinking in red
A full charge will supply enough
power for approx. 14 shaves (3 min-
utes per shave for a normal beard).

Cord shaving

Connect the shaver to the AC outlet
and turn the shaver on.
If the shaver does not run, charge it
for approx. 1 minute.

Using your shaver

Push the On/Off switch to turn the
shaver on. Hold the shaver at a right
angle (90

°) to your skin (see fig. 3).

Start out shaving by applying gentle
pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.

System outer foil
(see fig. 4)
System outer foil has a slit blade (a)
between 2 foils (b). They move up
and down independently to follow the
contours of your face.
The slit blade catches and cuts
longer and lying hairs easily.