Pioneer PDK-FS05 - Manual (Page 10)

10
En
List of parts and equipment included
Be sure to check that all the parts and equipment listed below have been included before beginning to assemble your stand.
• Note that a Philips screwdriver (not included) is required for assembly.
• Center support column x1 • Base x1 • PDP bracket x1
• Glass panel x1 • Glass stays
(x2, one left and one right)
• Long support legs x2 • Cable cover x1
(for attachment to
support column)
• Cap x1
• Support column covers
(x2, one left and one right)
• Hexagonal wrench x1
(Opposite side 6 mm for M8 use)
• Cable clamps x4
• Operating instructions
(This document) x1
• Middle hexagonal bolts (M8 x 35 mm: black) x4
• Short hexagonal bolts (M8 x 16 mm: black) x12
• Screws (M4 x 10 mm: silver) x4
• Screws (M4 x 10 mm: black) x2
Operating instructions
Mode d’emploi
Bedienungsanleitung
Istruzioni per l’uso
Gebruiksaanwijzing
Manual de instrucciones
Floor stand
Support de base
Bodenständer
Supporto per display
Vloerstandaard
Soporte para colocar en el suelo
PDK-FS05
ucciones
• Short support legs x2
• Long hexagonal bolts (M8 x 60 mm: silver) x2
Caution
The glass panel should be kept in its
packing box until you are ready to attach it
to the stand to guard against breakage.
(Please refer to the table for Procedure 3 on page 11 for usage.)