Read me first, Models for u.s.a./canada – Panasonic CF-08 User Manual
Page 6
6
Read Me First
on, the user is encouraged to try to cor-
rect the interference by one or more of
the following measures:
z
Reorient or relocate the receiving
antenna.
z
Increase the separation between the
equipment and receiver.
z
Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
z
Consult the Panasonic Service Cen-
ter or an experienced radio/TV tech-
nician for help.
Warning
To assure continued compliance, use
only shielded interface cables when
connecting to a wireless display or
peripheral. Also, any changes or modi-
fications not expressly approved by the
party responsible for compliance could
void the user’s authority to operate this
equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094
Tel No:
1-800-LAPTOP5 (1-800-527-8675)
FCC RF Exposure Warning:
z
This equipment complies with FCC
radiation exposure limits set forth for
an uncontrolled environment.
z
This equipment must be installed
and operated in accordance with
provided instructions and minimum
1.5 cm spacing must be provided
between antenna and all person’s
body (excluding extremities of
hands, wrist and feet) during wire-
less modes of operation.
z
This transmitter must not be co-
located or operated in conjunction
with any other antenna or transmitter.
Notice for the products using LCD
This product uses one or more fluores-
cent lamps containing a small amount of
mercury. It also contains lead in some
components. Disposal of these materi-
als may be regulated in your community
due to environmental considerations.
For disposal or recycling information
please contact your local authorities, or
the Electronics Industries Alliance:
I
For Use in Motor Vehicle
Warning: Wireless display may be
installed in a motor vehicle and visible to
the driver only if used to support vehicle
related functions such as vehicle infor-
mation, system control, rear or side
observation and navigation. If used for
entertainment purpose, such as televi-
sion reception or video play, it must be
installed to the rear of the driver’s seat
where it will not be visible, directly or
indirectly, to the operator of the motor
vehicle.
Check with individual state/provincial laws
to determine lawful use of this product
while operating within a motor vehicle.
Models for U.S.A./Canada
CF-08.book 6 ページ 2006年4月6日 木曜日 午後6時38分