Lexicon BD-30 - Manual (Page 85)

81
BD-30 Blu-ray Disc Player
Appendix
The illustration of the response structure is as follows:
=
[]
= @, ASCII 0x40
= OK|ER
= space, ASCII 0x20
= command-specific
= CR, ASCII 0x0d
Command Sequence:
Commands are executed in the order they are received. The host
should wait for a response from the player before sending the next
command.
If the player receives a new command before executing the
previous command, the player may discard the previous
command.
If the host does not receive a response from the player 10
seconds after the command is issued, the host may consider the
command or response lost during transmission, and can retransmit
the command.
Command List:
A. Command that maps to a remote control button
This group of commands maps directly to the infrared remote
control keys. No parameters are needed for these commands. The
player handles the commands as if it receives the same IR remote
commands. For actions that require multiple key sequence, such
as go to a certain chapter (GOT command followed by multiple
numeric key commands and the SEL command), the player
responds to each command individually until the last command is
received. At that time the player shall respond with either OK or ER
depending on the result of the action.
Code Remote Key Function Special Response
POW POWER Toggle power STANDBY and ON OK ON
OK OFF
SRC SOURCE Go to Home Menuto select media source
EJT OPEN Open/close the disc tray OK OPEN
OK CLOSE
PON ON Discrete on OK ON
POF OFF Discrete off OK OFF
SYS P/N Switch output TV system: NSTC, PAL or
MULTI(AUTO)
OK NTSC
OK PAL
OK AUTO
DIM DIMMER Dim front panel display OK ON
OK DIM
OK OFF
PUR PURE AUDIO Pure audio mode (no video) OK ON
OK OFF
VUP VOL + Increase volume OK n (n is the volume
number, 0 – 100)
VDN VOL - Decrease volume OK n (n is the volume
number, 0 – 100)
MUT MUTE Mute audio OK MUTE
OK UNMUTE
NU1 1 Numeric key 1
NU2 2 Numeric key 2