Lennox Hearth BT135 - Manual (Page 3)

GB GB
7. You will be asked for a Pass Key. Enter 0000.
8. Now go back to Accessory Settings, and select Audio Device Settings to check
that your Jabra BT135 is correctly selected as your chosen device. You may also set
the microphone volume level and test the device operation from within this section.
Congratulations! Your Jabra BT135 is paired with your PLAYSTATION®3.
WARNING!
Headsets are capable of delivering sounds at loud volumes and high pitched tones. Exposure to such sounds can result
in permanent hearing loss damage. The volume level may vary based on conditions such as the phone you are using, its
reception and volume settings, and the environment. Please read the safety guidelines below prior to using this headset.
Safety guidelines
1. Prior to using this product follow these steps:
• before putting on the headset, turn the volume control to its lowest level,
• put the headset on, and then
• slowly adjust the volume control to a comfortable level.
2. During the use of this product
• Keep the volume at the lowest level possible and avoid using the headset in noisy environments where you may be
inclined to turn up the volume;
• If increased volume is necessary, adjust the volume control slowly;
and
• If you experience discomfort or ringing in your ears, immediately discontinue using the headset and consult a physician.
With continued use at high volume, your ears may become accustomed to the sound level, which may result in
permanent damage to your hearing without any noticeable discomfort.
Using the headset while operating a motor vehicle, motorcycle, watercraft or bicycle may be dangerous, and is illegal in
some jurisdictions. Check your local laws. Use caution while using your headset when you are engaging in any activity that
requires your full attention. While engaging in any such activity, removing the headset from your ear area or turning off
your headset will keep you from being distracted, so as to avoid accident or injury.
3. Keep out of reach of children:
The plastic bags the product and its parts are wrapped in are not toys for children. The bags themselves or the many
small parts they contain may cause choking if ingested. Never try to dismantle the product yourself. None of the internal
components can be replaced or repaired by users.
Only authorised dealers or service centres may open the product. If any parts of your product require replacement for any
reason, including normal wear and tear or breakage, contact your dealer.
Avoid exposing the product to rain or other liquids.
4. ACA TS028 – Ignition of flammable atmospheres
Do not use the Headset in environments where there is a danger of ignition of flammable gases.
Getting Started
1. Charge your headset
Charging Fully Charged
2. Turning your headset on 3. Turning your headset off
Pairing your Jabra BT135 with PLAYSTATION®3
1. Prepare your PLAYSTATION®3 for pairing by going to
Settings on the Home Menu and selecting Accessory Settings.
2. Choose Register Bluetooth Device.
3. On the next screen, select Register Headset.
4. Ensure your Jabra BT135 is off. On your Jabra BT135, press
and hold the Answer/End button for five seconds, until
a solid blue light comes on, which places the device in
Bluetooth discoverable mode.
5. Select Start Scanning on your PS3™.
6. Your PS3™ will scan and locate the Bluetooth device.
Select it from the list that appears.
2 hrs
Do not dispose of this product with household wastes. To comply with European laws and to prevent possible harm
to the environment, please recycle it responsibly. Contact your retailer or local authority for guidance on where to take
your product at the end of its life.