Kompernass KH 1027 - Manual (Page 6)

- 4 -
Cleaning and Care
ƽ
Danger
Do not open any part of the housing. There are no
operating elements inside. An open housing can create
the risk of a life-threatening electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered
components.
Before cleaning the appliance,...
• first, remove the plug from the power socket and
allow the appliance to cool down completely.
• Clean the exterior surfaces and the power cable
with a slighly damp cloth. Be sure to dry the
appliance well before taking it back into use.
• For stainless steel surfaces, you can use appropriate
cleaning agents from a specialized dealer.
• Never use any cleansers, abbrasive substances
or solvents. These can damage the appliance.
In the event of scale deposits
• Before descaling, remove the pourer sieve 8
(see chapter "Removing/replacing the pourer
sieve").
• Take any decalcifying agent used for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a grocery shop. Proceed as detailed in the
instructions provided for the use of the decalcfying
agent.
Removing/replacing the pouring sieve
• Open the lid 1.
• Press from the front against the upper lug sitting
in the middle of the pouring sieve 8 and at the
same time hold it firmly by the flap.
• Remove the pourer sieve 8.
• Clean the pouring sieve 8 with a lightly moistened
dishcloth and under running water.
• After cleaning it, place the pourer sieve 8 from
inside against the opening. Ensure that the lower
and the lateral lugs grip the opening. Press the
pourer sieve 8 until the upper lug engages in
the opening.
• Should the scale deposits in the pourer sieve 8
be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve 8 with lots of clear water.
Storage
Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable around the cable winder 5
under the base 4.
• Store the appliance in a dry place.
IB_KH1027_E41844_LB6 26.11.2008 8:48 Uhr Seite 4