Kohler Karbon Kitchen Sink Tap K-6227A - Manual (Page 2)

2
1109784-A2-C
IMPORTANT INfORMATION
Due to the non-standard diameter of
the remote valve (51 mm), the remote
valve cannot be installed through a
standard 35 mm tap hole in a sink.
Choose a sink without tap holes
then install the tap and remote valve
through the countertop. Refer to the
countertop manufacturer for drilling
of the holes.
1. Make sure that you follow all
the local plumbing and building
regulations in operation.
2. For new installations, install the
tap in the sink before installing
the sink.
3. Before installation, unpack the
tap and inspect for damage.
Remote Valve
Tap
Plumbing Connections
G ½” Supply fitting connections
Hot (H) and Cold (C) inlets must be connected to the correct inlet supplies.
ASME A112.18.1-2005 / CSA B125.1-05:
Rated Pressure (section 4.1.1) - Fittings shall be designed to function at water
working pressures between 140 and 860 kPa (20 and 125 psi).
Rated Temperature (section 4.1.2) - Fittings shall be designed for rated supply
temperatures between 5° to 71° C (40° to 160° F).
Burst Pressure (section 5.3.2) - Fittings shall withstand a hydrostatic burst pressure
of 3450 kPa (500 psi) for 1 minute without distortion or failure of the pressure
envelope
SPECIfICATION
In-line water filters must be installed with this product