Conventions used in this document, Vanlink component set-up and operation, Warnings, cautions, notes, and hints – Kyocera VLSG-01 User Manual
Page 9: Warnings
CONVENTIONS USED IN THIS DOCUMENT
VanLink System featuring TouchStar™ Technology - Troll Systems Corporation
Introduction
Document VLSG-01 - 10/17/2008
P-5
CONVENTIONS USED IN THIS DOCUMENT
VanLink Component Set-up and Operation
The Troll Systems V750 Remote Site Controller and its innovative capabilities is the
heart of the VanLink system. For comprehensive information for this complex and
dynamic component, consult the Troll Systems manual for the S750 Remote Site
Controller manual which is identical to the V750 in almost all respects and functions.
Text appearing on the bottom line of the front panel display (just above the function
keys) of the V750 Remote site controller (i.e., commands associated with function keys
A, B, C, D, and E) appear in the font,
Arial Rounded MT Bold
Text and terms that are emphasized to draw the reader’s attention (due to their
significance within the text) appear in italics. See the example below.
WARNINGS, CAUTIONS, NOTES, AND HINTS
Warnings
Warnings are included to alert the user that possible hazards are associated with the
processes/procedures described. These may cause death or injury in any form, if the
instructions in the operational or procedural task are not followed precisely. Warnings
describe the potential hazards and possible impact that could occur if the warnings are
not observed.
WARNING:
This format is used for general warnings.
WARNING:
This format is used for electrical warnings.
WARNING:
This format is used for mechanical warnings.