Kawasaki 840108 User Manual

Page 28

ATTACHING / REMOVING BLADE

Failure to remove the battery pack from the saw before

removing the blade could result in accidental starting and serious personal
injury.

• Remove the battery pack.

• Use the allen wrench to loosen the blade clamp screw on the side of the saw by

turning it counter-clockwise. Do not remove the screw entirely.

TO ATTACH BLADE:
• Press the hole in the shank of the

blade onto the pin in the saw bar.
Make sure that the teeth of the
blade are facing downward.

• Tighten the blade clamp screw

back into place.

• Remove allen wrench.

• Replace the battery pack.

VARIABLE SPEED TRIGGER SWITCH

Never tape the trigger switch down to provide continuous

high speed. The tool may fail under such conditions causing fire or personal
injury.

The lock-off button helps prevent accidental starting.

This button can be pressed from either side.

THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Reciprocating Saw depends

on the amount of pressure applied on
the trigger. The further the trigger is pressed,
the faster the tool will go.

• Press the lock-off button, then pull the “ON/OFF” trigger to turn the Cordless

Reciprocating Saw “ON”. To turn the Cordless Reciprocating Saw “OFF”,
release the trigger switch.

TO REMOVE BLADE:
• Pull the hole in the shank of the blade

off the pin in the saw bar.

• Tighten the blade clamp screw back

into place.

• Remove allen wrench.

• Replace the battery pack.

TRIGGER

LOCK-ON

BUTTON

BLADE CLAMP