Konica Minolta BIZHUB 210 - Manual (Page 229)

When a message appears 8
bizhub 162/210 8-19
SET ORIGINAL TO ADF A document was not loaded
into the document feeder be-
fore beginning a copy function
(such as, “2in1” copying or
“Mixed orig.” copying) that
uses the document feeder.
Otherwise, the document
feeder is lifted up. Load a document into the
document feeder.
Securely close the document
feeder.
REMOVE PAPER When interrupting a copy job
to perform a different copy op-
eration other than the “Book
separation” function, the doc-
ument for the interrupted copy
job was left in the document
feeder. Remove the document from
the document feeder.
TEXT/P×1.00
¦[A]§#XXX:EMPTY
(While specifying copy set-
tings)
The selected paper tray has
run out of paper.
“#” indicates the paper tray,
and “XXX” indicates the paper
size. Either load paper of the speci-
fied size into the specified pa-
per tray, or press the [Paper]
key and select a different pa-
per size.
NO SUITABLE PAPER • While copying, the size of
the paper in the selected
paper tray has changed.
• While copying documents
with mixed sizes using the
auto paper function, paper
of a suitable size could not
be found.
“#” indicates the paper tray,
and “XXX” indicates the pa-
per size.
Either load paper of the speci-
fied size, or press the [Paper]
key and select a different pa-
per size.
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR While copying using the auto
paper function, paper of a
suitable size could not be
found. Either load paper of a suitable
size, or press the [Paper] key
and select a different paper
size.
AMS SIZE ERROR While copying using the auto
size function, the combination
of the document and paper
sizes caused the zoom ratio to
exceed the range between
×0.5 and ×2.0. Either load paper of a suitable
size, or use the [
,] and [+]
keys to specify the zoom ratio.
PAPER SIZE ERROR The paper loaded in the paper
tray caused a size error.
“#” indicates the paper tray,
and “XXX” indicates the paper
size. Pull open the paper tray with
the size error, and then close it
again.
Check if a custom paper size
has been entered, and correct
the paper size using the ap-
propriate utility mode function.
(Flashing alternately)
RESET PAPER (#XXX)
MEMORY FULL The size of the data for the
scanned image has exceeded
the capacity of the memory. Press any key, or turn the ma-
chine off, then on again. (The
scanned data should be
cleared from the memory.)
(Flashing alternately)
PRESS ANY KEY
Message Cause Remedy