Kyocera NS-L37Q-10A User Manual

Page 6

2. Press

MENU. The on-screen menu opens with the Picture

menu displayed.

3. Press

◄ or ► to highlight CHANNELS. The Channels menu

opens.

4. Press

▼ to highlight Channel Strength, then press

OK/ENTER or ► to open the DTV signal meter.

5. Move the antenna around the room or close to a window.

Check the signal strength of the digital channels again. The
optimal location may vary by channel.

6. Press

EXIT to close the menu.

o The UHF band (channels 14 and higher) is more directional than VHF

(channels 2-13) and more sensitive to obstacles (such as trees, tall
buildings, and mountains) that lie between your antenna and the
broadcast tower. Getting good UHF reception can be more difficult
than VHF.

o If you're getting marginal reception of digital signals, both the picture

and sound might freeze or break up to the point that it's not watchable.
If you're really on the fringes—either too far from a tower or with too
many obstacles in the way—you'll see a black screen that says "No
signal".

o Reception can vary by channel, depending on the location and

broadcast power level of a given station.

o Make sure your antenna is connected securely to the TV.
o Use a basic indoor set-top antenna designed to pick up both VHF and

UHF.

Use a set-top antenna that has a built-in signal amplifier.

Use an antenna mounted on your roof or in your attic

o For more information about antennas and the available channels in

your area, visit

www.antennaweb.org

7. I have an image issue (e.g., stripe on the screen, blue lines/dots, red line, etc.).

 Make sure your cables are connected correctly and securely to the jacks on the

TV.

 The cables you are using may be bad, try a new set.

 If you are using an antenna, the signal strength of the channel may be low.

o Check the signal strength of the digital channels:

1. Press

CH ▲ or CH ▼ to select the channel you want and to

view the selected channel strength.