Kawasaki MOJAVE 78473 - Manual (Page 9)

• Position the vehicle body upright.
• Fit and hold a rear wheel driver against the motor pins
on one end of the motor assembly.
• While holding the rear wheel driver in place, slide the
rear axle into the hole in the opposite side of the motor
assembly. Make sure the rear wheel driver on the rear
axle assembly fits onto the pins on the motor assembly.
• Take the rear wheel driver off the open end of the
rear axle.
3
Rear Axle Assembly
Rear Axle
Motor Assembly Pins
Rear Wheel Driver
Vehicle Body
Assembly
9
1
• Fit a cap nut onto one end of the rear axle.
• Tap the other end of the rear axle with a hammer to
secure the cap nut on the end of the rear axle.
Note: You may want to position the cap nut on a scrap
block of wood to protect the assembly surface.
• Slide a hex bushing, ring side first, onto the rear axle.
• Slide a hubcap, ring side first, onto the rear axle.
• Slide a wheel onto the rear axle. Make sure the ribs on
the wheel face up.
• Slide a rear wheel driver, ring side first, onto the rear
axle. Fit the grooves on the rear wheel driver onto the
ribs on the wheel.
• Slide a washer onto the rear wheel axle.
• Set the rear axle assembly aside.
2
Rear Axle
Cap Nut
Washer
Wheel
Hex Bushing
Rear Wheel Driver
Ribs Up
Hubcap
F