Kawai LH-1 - Manual (Page 26)

26
2. Change Assignment
After you have entered SYSTEM MODE and have selected Speaker Assignment using
the appropriate Select Button, the Display will show the seven PIANO and ORGAN
sounds. Press the PIANO 1 Select Button. The Internal box will be highlighted to
indicate that the LH-1’s Internal Speaker System is now active for this sound. Press the
All Speakers function button to change this assignment. Once All Speakers is selected,
the LH-1 will send sound to both the Internal Speakers and the External Outputs (where
optional External Powered Speakers can be connected).
Now, press the BACK button three (3) times. With the third press, a window will open
that says “Saving The Data Please Wait !” Once this statement disappears, the change
will have been made in the LH-1’s computer memory. The PIANO 1 sound will then be
heard through the Internal Speakers and any optional External Powered Speakers that are
connected to the Line Out jacks.
If you re-enter the SYSTEM MODE to check the Speaker Assignment, you should see
that the All Speakers box is highlighted for PIANO 1. To return to the original setting,
select Internal and press the BACK button three (3) times to save the new setting and
exit.
You can use this process to select a separate Speaker Assignment for each of the LH-1’s
seven sounds.
Internal
Choose Internal to hear the LH-1 sounds only through the Internal Speaker System.
This is the default Factory Setting for the two PIANO sounds.
External
Choose External to hear the LH-1 using only an optional External Speaker System that
may be connected to the LH-1’s Audio Output Jacks located under the right side of the
keyboard. Choosing External disconnects the LH-1’s Internal speaker system.
External assignment will normally be used with ORGAN sounds.
NOTE: Do not choose External if there is no External Speaker System connected
to the LH-1.
All Speakers
Choose All Speakers to hear the LH-1 using both the Internal Speaker System and an
optional External Speaker System connected to the LH-1. Choosing All Speakers will
give you maximum sound power distribution. This is the default Factory Setting for all
ORGAN sounds.
NOTE: You must change Speaker Assignments individually for each sound. There
is no global assignment.