Kompernass KH 1023 - Manual (Page 5)

- 3 -
Operating Elements
q Handle
w Lid with knob
e Scale
r ON/OFF switch with integrated
pilot light
t Base
y Pourer sieve
Start-up
ƽ
Important
Always and only use freshly drawn mains water in
the kettle! Do not consume any water that is not
certified as potable. If you do, you are taking a risk
with your health!
• Before taking the appliance into use, ensure that ...
• the appliance, the plug and the power cable are
in good working order and...
– the power cable been completely unwound from
the holder on the bottom of the appliance, and
that...
– all packaging materials have been removed
from the appliance.
• Fill the appliance with water up to the MAX
mark and let it come to a full boil once – as
described in the next section.
• Pour this water away after the water has been
boiled.
• Rinse the water boiler out with clear water.
• Fill the appliance with water once again up to the
MAX marking on the scale e and then bring it
to the boil. When done, pour this water away
also.
The appliance is now ready for use.
Boiling water
ƽ
Danger
Never place the electrical base t adjacent to water
– a potentially fatal risk!
• Lift the kettle off of the base when filling it!
• Remove the lid
w in that you pull it upwards.
• Hold the kettle upright while filling it. Only in this
way can you correctly read the markings on the
scale
e .
Fill the kettle ...
– at least to the MIN mark, so that the device does
not overheat,
– no higher than the MAX mark, so that no boiling
water spills out.
• First close the lid w ...
• and then place the kettle on the base t such
that it is standing absolutely upright on the base t .
• Now insert the plug into the mains power socket ...
• and press the ON/OFF switch
r downwards
until it engages.
• The pilot lamp integrated into the ON/OFF
switch r indicates that the appliance is now
heating the water up.
• The appliance switches itself off and the pilot
lamp goes out as soon as the water is on the
boil. The ON/OFF switch
r springs upwards.
ƽ
Warning
Remove the plug from the mains power socket before
you lift the kettle from its base
t . This prevents causing
a potential short circuit by water possibly spilling
out of the carafe and falling onto live electrical
connections in the base
t .
ƽ
Injury hazard
For safety reasons, the lid w should not be opened
while the water is boiling or is very hot.
There is a risk of receiving severe scalds.
IB_KH1023_35335_LB6.qxd 20.07.2009 14:37 Uhr Seite 3