Smeg 633ST - Manual (Page 4)

GB
3
The washing machine is a domestic appliance capable of washing any type of fabric at
any time.
✔
The machine has been constructed in steel panels which have been treated and
painted to guarantees that its aesthetic qualities remain unaltered over time.
✔
The motor and all moving parts have been designed and manufactured to guarantee
the minimum possible noise levels.
✔
The large well-mounted stainless steel drum will ensure a better quality wash and help
to prolong the life of your washing.
✔
The easy to use control panel will satisfy all your washing and drying needs (see control
panel and programme table).
✔
The wide door makes loading and unloading your washing much easier.
✔ The very high stability of the machine is the result of extensive research by our technicians
on the equilibrium of masses in movement.
Installation must be carried out by qualified personnel in line with the instructions supplied
by the manufacturer. Incorrect installation may result in damage and injury.
The machine can be installed anywhere providing the ambient temperature is not less
than 3
° C and the wires or pipes on the rear of the machine are not squashed.
DESCRIPTION OF THE MACHINE
INSTALLATION
▼ For transport reasons, the machine’s oscillating group is locked in place by 4 spacers
and screws. Before using the machine, remove the spacers and locking screws.
Keep the screws and spacers for future use.
▼ For transport reasons, the machine’s oscillating group is locked in place by 4 spacers
and screws. Before using the machine, remove the locking screws with a suitable spanner.
WARNINGS
V
▼ Close off the holes using the plugs supplied. The plugs can be found in the bag
containing the documents.
N.B. If the spacers cannot be removed from the machine in this way, open the rear panel,
remove them and replace the panel.
▼ Insert a screwdriver in the holes and lever out the 4 plastic spacers as shown in the
figure.
N.B. If the spacers cannot be removed from the machine in this way, open the rear panel,
remove them and replace the panel.