Samsung FE-N300** - Manual (Page 24)

24_ Surface cooking
uSinG The Touch conTrol SenSorS
If more than one touch sensor button is pressed for longer
than 1 minute, will show in the heat setting display. To
reset, touch the
On/Off control sensor.
hoW To SeT The aPPliance For cookToP cookinG
CAUTION
The cooktop elements may be hot and burns may occur. Do not touch the surface •
elements until they have cooled down sufficiently.
At high or over the 6 level, never leave food unattended. Boilovers cause smoke. •
Greasy spillovers may catch on fire.
Be sure you turn the Touch control to • OFF when you finish cooking.
SelecT cookinG zone on
1. To switch on the cooking zone, touch On/Off control sensor.
2. The digital displays will show .
After the On/Off control sensor has been activated to switch on your appliance, a heat
setting must be selected within approximately 5 seconds. Otherwise, the appliance will
switch itself off for safety reasons.
heaT SeTTinG
1. Radiant Burner
a. In the next 5 seconds, move your finger along the control
panel until the desired heat level setting appears in the
digital display.
Select the Low touch sensor for the lowest power level. •
Select the Hi touch sensor for the highest power level. •
b. To set and adjust the power level from (
to ) for
cooking, touch the Heat level setting selectors (+ or -).
To operate the touch control sensors, touch the desired panel with the tip of your pointed
finger until the relevant displays illuminate or go out, or until the desired function is activated.
Ensure that you are touching only one sensor panel when operating the appliance. If your
finger is too flat on the panel, an adjacent sensor may be activated as well.
FEN300WX DG68-00283A_EN.indd 24 2010-02-24 �� 9:34:31