Sennheiser EM 2000 - Manual (Page 4)

Important safety instructions
2
Important safety instructions
1. Read these instructions.
2. Keep these instructions. Always include these instructions when passing the receiver on
to third parties.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two blades
and a third grounding prong. The wide blade or the third prong are provided for your
safety. If the provided plug does not fit into your outlet, consult an electrician for replace-
ment of the obsolete outlet.
10.Protect the power cord from being walked on or pinched, particularly at plugs, conve-
nience receptacles, and the point where they exit from the apparatus.
11.Only use attachments/accessories specified by the manufacturer.
12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when moving the cart/appa-
ratus combination to avoid injury from tip-over.
13.Unplug this apparatus during lightning storms or when unused for long periods of time.
14.Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been damaged in any way, such as power
supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, when the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
15.To completely disconnect this apparatus from the AC mains, disconnect the power supply
cord plug from the AC receptacle.
16.WARNING: To reduce the risk of fire or electric-shock, do not expose this apparatus to rain
or moisture.
17.Do not expose this equipment to dripping or splashing and ensure that no objects filled
with liquids, such as vases, are placed on the equipment.
18.The mains plug of the power supply cord shall remain readily operable.
Hazard warnings on the rear of the receiver
The label shown on the left is attached to the rear of the receiver. The symbols on this label
have the following meaning:
This symbol is intended to alert the user to the presence of uninsulated dangerous voltage
within the receiver’s enclosure that may be of sufficient magnitude to constitute risk of fire
or electric shock.