Sennheiser EVOLUTIONWIRELESS SKP 100 User Manual
Page 17
16
Adjusting settings via the operating menu
Activating/deactivating the pilot tone transmission –
“Pilot Tone”
The plug-on transmitter adds an inaudible pilot tone to the audio signal.
The receiver detects and evaluates the pilot tone, and is thus able to iden-
tify the signal of the matching transmitter and mute all others. The pilot
tone supports the receiver’s squelch function.
Devices of the ew 100 G1 series (generation 1) do not support the pilot
tone function. Therefore, please observe the following when combining a
transmitter or receiver of the ew 100 G3 series (generation 3) with devices
from an earlier evolution wireless generation:
Adjusting the contrast of the display panel – “LCD Contrast”
You can adjust the contrast of the display panel in 16 steps.
Loading the factory-preset default settings – “Reset”
When resetting the plug-on transmitter, only the selected settings for the
pilot tone and for the frequency bank “
U
” remain unchanged.
For an overview of the factory-preset default settings, refer to the
supplied frequency information sheet.
Displaying the software revision – “Software Revision”
You can display the current software revision of the plug-on transmitter.
Transmitter
Receiver
Make sure to ...
w G3/
w G2
w G3/
w G2
... activate the pilot tone
function on both trans-
mitter and receiver.
w G3
w G1
... deactivate the pilot tone
function on the ew 100 G3
transmitter.
w G1
w G3
... deactivate the pilot tone
function on the ew 100 G3
receiver.
Call up
“Pilot Tone”
Select the desired
setting
Store the setting
Name
Advanced
Menu
Pilot Tone
A c t i v e
Pilot
I n a c t i v e
Pilot
“Stored”
SET
SET
Select the desired
setting; apply the
setting
Call up “Reset”
Advanced
Menu
Reset
Yes
Reset
“Stored”
SET
SET
SKP100_529675_0409_Sp9.book Seite 16 Donnerstag, 9. April 2009 1:48 13