Sennheiser EM500 - Manual (Page 23)

Using the receiver
22
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 500 G3 series with
the receiver. If the receiver is in ex works condition, the following parame-
ters are transferred to the transmitter during synchronization:
To transfer the parameters:
̈
Switch the transmitter and the receiver on.
̈
Press the button
»
on the receiver.
“ Sync ” appears on the display panel of the receiver.
̈
Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface
¿
of the
receiver.
The parameters are transferred to the transmitter. When the transfer
is completed, “
” appears on the receiver’s display panel. The receiver
then switches back to the current standard display.
Setting Transferred parameters
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver
(“
Inactive ”/“ Active ”)
Via the “ Sync Settings ” submenu, you can adjust the parameters to
be transferred to your transmitters (see page 41). It is vital to
observe the notes on frequency selection on page 45.
¿
»
¿
»