Woodstock ACCU-SHARP D3978 User Manual

Model d3978 accu-sharp, Grinding jig, Instructions

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in China

#11386TS

MODEL D3978

ACCU-SHARP

GRINDING JIG

INSTRUCTIONS

To reduce the risk of serious injury when using

this grinding jig, take the following precau-

tions:

1. GRINDER OWNER'S MANUAL. Read

and understand the owner's manual for your

grinder and always follow all of the safety

precautions and instructions for your grinder.

2. EYE/FACE PROTECTION. Always wear

safety glasses or a face shield to protect your-

self from flying material.

3. HAND PLACEMENT. Always keep your

hands and fingers away from the spinning

grinding wheel, and protect yourself from the

sharp edges of the tool.

4. SECURE CLAMPING. Make sure the tool is

securely clamped in the jig and that the table is

firmly locked in the proper position.

Introduction

The Model D3978 Accu-Sharp

Grinding Jig works

with the tool rest table of your grinder to properly posi-

tion chisels and plane irons up to 2

⁄

" wide, as shown

in Figure 1. The tool clamping jig uses a special

plastic rod and pads to slide the tool from side-to-side

across the auxiliary table and the grinding wheel.

If you need help with your new grinding jig, call

Woodstock Tech Support at: (360) 734-3482.

Figure 1. Using the Accu-Sharp Jig to grind the bevel

of a flat chisel.

Inventory

After removing the contents of the shipping package,

lay them out and refer to Figure 2 to inventory the

components.

Figure 2. Model D3978 inventory.

Mounting

Screws

Auxiliary

Table

Tool

Clamping

Jig