Sangean DT-220V - Manual (Page 5)

4
Installing batteries
1. position the radio face down.
2. Press the catch and slide in the direction of the
arrow.
3. Lift up the battery cover.
4. Insert 2xUM-3 (AA) size batteries. Make sure the
batteries are positioned in accordance with the
diagram indicated.
5. Replace the battery cover.
Battery replacement
The battery indicator will appear and flash in the
display when the batteries are in need of replacement
. After removing the batteries, you have
approximately 3 minutes to replace the batteries after
which clock and memory information will be lost.
Setting the clock time
The clock will start running when the batteries are
installed. When the batteries are installed for the first
time, the display will show 0:00.
Note:Time can only be set with the radio switched off.
1. Ensure that the radio is switched off .
2. Press and hold down the Time Set button for more
than 2 seconds until the hours digit begins to flash
in the display .
3. Whilst the hours digit is flashing, adjust the hours
using Tuning Up/Down buttons.
4. Press the Time Set button, the minute digit begins
to flash in the display.
5. Whilst the minute digit is flashing, adjust the
minutes using the Tuning Up/Down buttons.
6. Press the Time Set button to complete time setting.