Sony WM-EX122 User Manual
Ex122, Getting started, Playing cassette
![background image](/manuals/147295/1/background.png)
Operating the Cassette Player
To wind the tape
Press
0 or ).
To adjust the volume
Turn the VOLUME
control.
To stop
Press
p STOP.
Notes on playing cassettes
• Do not use cassettes longer than 90 minutes except for long
continuous playback.
• If the tape is playing but no sound comes out, the batteries may be
weak. Replace all batteries with new ones.
• If your Walkman has not been used for a long time, run the
Walkman for a few minutes before inserting a cassette.
• Do not open the cassette holder while the tape is running.
• Do not wind the headphones cord around the Walkman. The
buttons may be kept pressed, causing unnecessary battery usage.
Using MEGA BASS
Set the MEGA BASS switch to ON to produce deep and
powerful sound.
When using MEGA BASS
If the AVLS switch is set to LIMIT, the MEGA BASS effect is reduced.
3-810-695-13(1)
Printed in Malaysia
Sony Corporation © 1996
Cassette Player
WM
-EX122
Operating Instructions
WALKMAN is a registered trademark of Sony Corporation.
OWNER’S RECORD
The model number is located at the rear and the
serial number is located inside the cassette holder.
Record the serial number in the space provided
below. Refer to them whenever you call upon your
Sony dealer regarding this product.
Model No. WM-EX122
Serial No.
Getting Started
Using with Batteries
Insert two AA (R6) batteries in correct polarity.
Notes
• When you are not going to use your Walkman for a long time,
remove the batteries to prevent damage from battery leakage and
corrosion.
• When the batteries become weak, the sound will be unstable or can
not be heard. In such a case, replace both batteries.
• Concerning the battery life, see “Specifications”.
Using External Power Sources
You can connect the following external power sources
through the DC IN 3 V jack located on the bottom.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
•House current using an AC-E30HG AC power adaptor
Note
Use only the recommended
AC-E30HG AC power adaptor (not
supplied). Do not use any other AC
power adaptor.
1
Insert a cassette.
2
Select the NORM or
CrO
2
/METAL mode to
match the tape type.
3
Press the
9 PLAY.
Playing Cassette
NORM
CrO
2
/
METAL
PLAY
2
pSTOP
VOLUME
NORM CrO
2/
METAL
0 )
9PLAY
Cassette holder
MEGA BASS
AA (R6) x 2
DC IN 3V
ON
OFF
Polarity of the plug