Fcc statement, Third party software libraries – Sager Electronics STP-HD200 User Manual
Page 12
SageTV HD Media Extender
Page 12
Model STP-HD200
Copyright 2008 SageTV, LLC All rights reserved
For additional support, go t
or email us at
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
- Consult the dealer or an experienced radio/TV technician for help
Third Party Software Libraries
This product contains the following open source software which is covered under their
associated licenses: the linux kernel, busybox, udhcp, init, telnetd, inetd, phoneme advanced,
libjpeg, libpng and ffmpeg.
For source code availability; please contact