Sony CDP-CX270 - Manual (Page 5)

Playing CDs Getting Started Getting Started
5 EN
When connecting to an amplifier without a video input
jack When connecting to an amplifier with a video input jack
CD player Amplifier
When connecting to an amplifier without a video input
jack
CD player
LINE
OUT
L
R
L
R
IN
MONITOR OUT INPUT
VIDEO
AUDIO
L
R
CD
L
R
• If you have a Sony receiver (amplifier) equipped with
the CONTROL A1 jack
Be sure to connect the player to the VIDEO 2 jacks on the
receiver (amplifier). When making this connection, leave
the COMMAND MODE of the player to CD2 which is set at
the factory.
If you further connect the player and the receiver
(amplifier) via the CONTROL A1 jacks with the CONTROL
A1 cord (not supplied), you can use the Automatic Function
Selection feature between these components. For details,
refer to the supplementary “CONTROL-A1 Control
System” instructions and the instructions supplied with the
receiver (amplifier).
• If you have a Sony receiver (amplifier) with the
On-Screen Display Control function
You can control the player using the on-screen display and
the remote supplied with the receiver.
For details, see page 22.
Amplifier
TV
LINE
OUT
L
R
L
R
IN
MONITOR OUT VIDEO
VIDEO IN
AUDIO IN
CD player
To an AC outlet
What cords will I need?
Audio cord (1) (supplied)
TV
To LINE OUT To MONITOR OUT
To video input
To audio input
To an AC outlet
Amplifier
To an AC outlet : Signal flow
White
(L)
Red
(R)
Video cord (1) (supplied)
Yellow Yellow
White
(L)
Red
(R)
Hookups
When connecting the cords, be sure to match the color-
coded plugs to the appropriate jacks on the
components: Yellow (video) to Yellow, Red (right) to
Red and White (left) to White. Be sure to make
connections firmly to avoid hum and noise.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
(Continued)