Sunbeam EM0450 - Manual (Page 11)

9
Care and Cfeaning (continued)
9. Replace the top burr back into position
in the grind adjustment collar. Ensure the
marker on the top burr is aligned with the
marker inside the grind adjustment collar
and push firmly into place.
Turn clockwise to the desired grind setting.
Adjusting the burrs for wear
The conical burrs are made of tool
hardened steel for extra long life. However
after prolonged use the burrs will require
adjustment to compensate for wear. A sign of
this is when the grinds are not as fine as they
used to be, check by rubbing some of the
grinds between two fingers or for espresso the
extraction will also show signs that the grind
needs adjusting.
Replacing the burrs
To inquire about having the burrs replaced
contact the Sunbeam Consumer Hotline
on FreeCall
Australia
1800 025 059
New Zealand
0800 786 232