Sony UP-DR100 - Manual (Page 13)

O
per
at
ion
Loading the Paper and Ink Ribbon
13
If the ribbon breaks during use
The remaining ribbon can be used after repairing it with
adhesive tape.
1
Pull out the lower ribbon of the blue spool, attach
one edge of a strip of adhesive tape over the entire
end of the ribbon, then attach the other edge of the
adhesive tape on the end of the upper ribbon of the
pink spool.
2
Turn the lower blue spool in the direction of the
arrow to remove the slackness of the ribbon.
The ribbon is ready to be used. Depending on the
position of the break in the tape, the ribbon for one
sheet of printed paper may be lost.
Removing the ink ribbon and paper
1
Remove the scraps of paper ejected and
accumulated on the paper scrap tray.
Note
If scraps of paper have accumulated on the paper
scrap tray, the front door may not open completely.
2
Pull the top of the front door to open it.
3
Push the right blue spool to the left and pull it
toward you to remove the blue spool of the ink
ribbon.
4
Wind up the loose ink ribbon.
Wind the spool
to feed the
ribbon out. Attach one edge of adhesive
tape over the entire end of the
ribbon and attach the other
edge of the adhesive tape on
the end of the upper ribbon.
Wind the spool in
the direction of the
arrow to remove the
slackness of the
ribbon.