John Deere STARFIRE PC20235 User Manual
Page 13
![background image](/manuals/134426/13/background.png)
Installation Instructions
OUO6050,00004FA
–19–10DEC03–2/3
N64444
–UN–12DEC03
CAUTION: Always attach harness to power
source before connecting STARFIRE receiver
harness. Make sure power inverter has a
minimum capacity of 3 amps. A smaller inverter
could overheat or cause operational problems.
If a battery is used, it is recommended to
permanently attach eyelet terminals to 12V
battery. Use of alligator type clips is not
recommended as they can expose operators to
sparks.
4. Connect receiver harness to power harness.
5. Connect power harness to power inverter or battery.
6. Use enclosed VELCRO
straps to secure harness.
7. Attach GREENSTAR display to harness.
8. Power system.
VELCRO is a trademark of Velcro Industries B.V.
OUO6050,00004FA
–19–10DEC03–3/3
JOHN DEERE
A
B
C
D
E
F
G
RTK Operating Mode
ABSOLUTE BASE
RTK Network ID
(1-4000)
GPS
Configure
Repeater Radio
SETUP
PAGE 3
RTK Radio
Channel (1-14)
Edit Stored RTK Base
Locations (1-20)
1
1
PC8022
–19–13NOV03
9. Enter RTK activation. See RTK Operator’s manual.
10. Go to SETUP/STARFIRE/PAGE3.
•
Set RTK Operating Mode to ABSOLUTE BASE.
•
Set RTK Network ID to match Vehicle Network ID.
•
Set RTK Radio Channel to match Vehicle Radio
Channel.
IMPORTANT: Base station coordinates are stored in
receiver. If receiver is changed these
values can be entered into display for
new receiver if operator does not want
to perform another 24 hour survey.
11. Record base station location ID and coordinates.
PC20235 (18DEC03)
11
Installation Instructions
121803
PN=13