iSimple PGHVW1 - Manual (Page 7)

4
9. With all connections made, reconnect the vehicle’s battery, insert the
key into the ignition, and turn the vehicle on. Check for proper operation
of the Media Gateway and HD Radio tuner or Satellite Radio tuner before
reinstalling the factory dash panels.
10. When first powering up the vehicle with the radio reconnected,
“CODE” may appear on the screen. This is a safety feature of the VW
radio. If you see this message, DO NOT enter a code, simply let the
radio sit on this screen for about 10 seconds, then turn the vehicle
off. Disconnect the gateway harness from the vehicle. Reconnect the
gateway harness to the vehicle. Normal operation should resume.
11. NOTE: The first time that you access the Gateway, your radio may
display “DEV INIT” while the device is initializing. If this is displayed,
please wait one minute the cycle the ignition off and on. Access “SAT”
mode again to begin normal gateway operation.
6. iPod Operation
Entering Mode Select Menu
Press the “SAT” button. Press the “CAT FLDR” ▲ or ▼ button to cycle
through the Media Gateway sources until IPOD is displayed. Wait 6
seconds and the radio will select the displayed option.
PLEASE NOTE: If you are listening to Satellite Radio and wish to
switch the Media Gateway source, you must press the TUNE KNOB
twice before pressing the
“CAT FLDR” ▲ or ▼ button. If the radio still
does not go into the mode select menu, press and hold the TUNE
KNOB until the radio menu is displayed. Turn the TUNE KNOB until
the radio displays”SELECT SCAN SAT”. Press the preset button
underneath “Channels”. Press and hold the TUNE KNOB to exit
the radio menu. You should now be able to access the mode select
menu.