St2 operation, Uno-lrc1 remote control with cav6.6 – Integra ST2 User Manual

Page 19

UNO-LRC1 Remote Control Operation

Turning the unit on

The tuner is power managed by the CAV6.6 or other

RNET-enabled controller. If the tuner is in standby

mode, any button press of the UNO-LRC1 will bring

the tuner out of standby mode when used with the

UNO keypad.

Selecting the desired tuner

To select a tuner, push

and choose the source

number preassigned to Tuner 1 or Tuner 2, or use the

UNO numeric source inputs at the bottom of the

UNO-LRC1.

Selecting the desired band

Push

to toggle between AM/FM reception.

Selecting the desired frequency

Use the Channel

and

for manual tuning. To move quickly through the

stations, press and hold the button for more than 1.5

seconds. To directly select a station, enter the three-

or four-digit frequency (1071 for 107.1, etc.).

European regions use five-digit station frequencies.

Frequency Seek

The SEEK function is performed by pressing and

releasing the Select

. To seek

higher frequency station press

. Press

for

lower frequencies. Tuning begins at the current fre-

quency, seeks upward (or downward) and stops at the

next tuned station. Pushing

again con-

tinues the SEEK function. Once the highest frequency

is reached, the tuner continues SEEK mode at the

lowest frequency.

Frequency Scan

To scan, press and hold then release

. The

tuner scans through tuned stations with a 5-second

preview before moving to the next station. To end

scanning, press

again.

Selecting a Bank

To select a bank, press and hold

for bank up

for bank down.

Recalling a Memory Preset

Press and

or and to

scroll

through a loop of all the memory presets for the cur-

rently selected bank. Only configured presets will be

displayed.

Mute

Press the

button to mute/unmute the tuner

audio output.

ST2 OPERATION

UNO-LRC1 REMOTE CONTROL WITH CAV6.6