beautypg.com

Invacare ISOBAR HT500PC User Manual

Save these instructions, Safety summary, Installing the adapter plate (figure 1)

background image

SAVE THESE INSTRUCTIONS

NOTE: Check all parts for shipping damage before using. In case of damage, do not use. Contact the

dealer for further instructions.

SAFETY SUMMARY

The following reccommendations are made for safe installation and use of the

Headrest Adapter Plate:

GENERAL WARNINGS

DO NOT install this equipment without first reading and understanding this

instruction sheet. If you are unable to understand these Warnings, Cautions

and Instructions, contact a healthcare professional, dealer or technical person-

nel if applicable before attempting to install this equipment - otherwise, injury

or damage may occur.
Your therapist and physician should be consulted if you have any questions

regarding individual limitations and needs.

INSTALLATION WARNING

Make sure that all screws and adjustments are tightened properly, otherwise

serious injury or damage may result.

INSTALLING THE ADAPTER PLATE (FIGURE 1)

1. Perform one (1) of the following:

ULTIMATE AIR OR KSS BACK - Turn the adapter plate so the "A" side faces up.
CONTOUR U

®

- Turn the adapter plate so the "B" side faces up.

2. Align the center mounting holes on the adapter plate with the threaded holes in the

bracket base.

NOTE: The slotted side of the bracket base should face out.
3. Secure the adapter plate to the bracket base with the four (4) mounting screws. Securely

tighten with the 1/8-inch allen wrench.

4. Align the four (4) slotted holes in the adapter plate with the holes in the back cushion

plate. Ensure that the side determined in STEP 1 faces up.

5. Perform one (1) of the following:

ULTIMATE AIR OR KSS BACK - Secure the adapter plate to the back with the four

(4) 3/4-inch cap screws. Securely tighten with the allen wrench.
CONTOUR U

®

- Secure the adapter plate and two (2) threaded backing plates to the

back with the four (4) 1/2-inch cap screws. Securely tighten with the allen wrench.

NOTE: The Headrest Adapter Plate Kit contains two (2) types of screws for securing the adapter plate to

the back: 3/4-inch screws for the Ultimate Air or KSS back and 1/2-inch screws for the Contour U

®

.

Headrest Adapter Plate

Assembly, Installation and Operating Instructions

Part No. HR15