iSimple ISBT21 - Manual (Page 7)

7
6. Warranty Information
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction.
This warranty applies only to the original purchaser of this product from an authorized
ISimple Solutions dealer. This warranty covers any supplied or manufactured parts of this
product that, upon inspection by ISimple Solutions authorized personnel, is found to have
failed in normal use due to defects in material or workmanship. This warranty does not
apply to installation expenses. Attempting to service or modify this unit, operating this unit
under conditions other than the recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, ISimple Solutions shall not be liable for any
personal injury, property damage and or any incidental or consequential damages of any
kind (including water damage) resulting from malfunctions, defects, misuse, improper
installation or alteration of this product. All parts of this ISimple Solutions product are
guaranteed for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above, ISimple
Solutions will repair or replace the product at their discretion, if it is defective in material
or workmanship providing it is returned to an Authorized iSimple Solutions Dealer, with
PROOF OF PURCHASE from an authorized ISimple Solutions dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical
for help.
Notice : The changes or modifications not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
FCC ID: XBD-PXAMGBT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this devicemay not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.