Ingersoll-Rand FE595 - Manual

Mark Lock Centerline on Door Face and Door Edge
2
38” from finished floor
Mark and Drill Hole in Door Face with 2
¹⁄₈
” Hole Saw
3
1
1 ³⁄₄ ” - 1 ³⁄₈ ”
Measure Door Width
If the door is thinner than 1 ³⁄₈ ” or thicker than 1 ³⁄₄ ”, then the lock will not
fit properly on the door.
Door Edge
Door Face
Tape
Mea
sure
Tap
e Measure
Mark and Drill Hole in Door Edge
4
FE575/FE595 Door Preparation Instructions
For Door With No Holes
Tools Needed
Tape
Mea
sure
Drill Bits Needed:
¹⁄₈ ”, ⁷⁄₈ ”, 1”
2¹⁄₈ ” Hole Saw Pencil Chisel
2 ³⁄₈ ” or 2 ³⁄₄ ”
2 ¹⁄₈ ” Hole Saw
⁷⁄₈ ” Drill Bit
a b
c d
Tap
e Measure
FOR
OR
FOR
¹⁄₂ ” Door
Width
Tape
Mea
sure
1 ” Drill Bit
OR
¹⁄₂ ” Door
Width
Tape
Measu
re
a b
c d
a b
c d