InStep SB100 - Manual (Page 2)

2
IMPORTANT
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. We regret that although great care and effort have been taken, occasionally problems may
occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of
problems, or to answer questions, please contact us at either our Toll-Free Customer service Number or
Email us at our number listed below. Service will be quicker if you have your model number (found on the
product and box) along with this instruction sheet ready when calling. If you have any questions concerning
the safe use of this product, Please contact us 1-800-242-6110 press “1” for customer service and then “2 “to
speak to a representative or E-mail us at [email protected] or visit our web site at www.instep.net
SB100 Assembly Instructions
Parts List
Description Qty.
Frame assembly with seat, belly bar and headrest 1
Canopy 1
Dual Front wheel assemblies with booties 2
Rear wheel axle assembly 1
Stroller Assembly Instructions
Step 1. Unfold Stroller
Push in the handle buttons located on each side of
the stroller (Picture A). While holding buttons, grasp
handle on each side, lift up so stroller raises off the
ground. Shake gently - the stroller will automatically
unfold. Continue extending handle until the handle
buttons snap into place.
Lift up on the front belly bar until it snaps into place
(Picture B). To lower belly bar for storage, push in
the latches located on each side of the belly bar
(under the material) and then push belly bar down
(Picture C). Return belly bar to upright position so it
snaps in place.
A
C B
Frame
Assembly Rear
Wheel Axle
Front
Wheels
w/Booties
Canopy
Belly Bar
(down
position)
Belly Bar
Latches (under
material
Handle
Buttons
Rear Leg
Front
Leg
Belly
Bar
Back
Rest
Up
Down
Belly
Bar
Latches
Belly Bar
Latches
(under
material)