Ironman Fitness Achiever - Manual (Page 6)

Note: Do not tighten Screws until
you have fully completed Figure 2.
6
Getting Started - The Ironman Fitness Achiever Elliptical will require some assembly. Unpack
the box in a clear area. Remove packing material. Do not dispose of packing material until
assembly is complete and unit is working properly. Place the unit on a clean level surface for
assembly. Make sure there is easy access to an electrical outlet. Before assembling, the unit
should be placed as close as possible to its final location. Locate all hardware bags, labeled
Figure 1 through Figure 9, with the exception of Figure 8. If you are missing any bags, please
call Ironman Fitness at 1-800-750-4766. Tools have been provided for use while assembling
this product.
Assembly
Figure 1
M10*80 HEX SCREW
CROWN NUT, M10*1.5
M10*120 HEX SCREW
UPPER CONSOLE WIRE
LEAD WIRE ASSEMBLY
CONSOLE TUBE
Figure 1
Locate bag labeled Figure 1. Locate
Console Tube. Attach Console Tube to
Main Frame. Slide Tube down into Main
Frame. Connect Upper Console Wire
to Lead Wire Assembly. Secure using
three M10*80 mm Hex Head Screws
extending through the frame and
Console Tube, three 10x20 Washers and
three Crown Nuts, M10*1.5. Use three
M10*120 Hex Screw to secure through
the Front of the Console Tube and Main
Frame.
Note: Ensure that all wires are secure
inside console. Be careful not to pinch
wires.