Integra DTR-5.2 - Manual (Page 31)

31
Input Setup
IntelliVolume
When switching input sources, you may find that the output level for
different components or input sources connected to the DTR-5.2 is
different even though the main volume setting is the same. Under
normal circumstances, you would then have to change the volume
setting each time you change the input source. This IntelliVolume
allows you to preset a volume level for each input source separately
so that when you do switch from one input source to another, the
DTR-5.2 adjusts the volume accordingly so that the resulting
volume stays the same.
1. Select the desired input source.
2. Press the Setup (SETUP) button.
Turn the jog dial or press the and cursor
buttons on the remote controller to display
“2. INPUT SETUP”
3. Press the jog dial or ENTER button
on the remote controller.
Turn the jog dial or press the and cursor
buttons on the remote controller to display
“12V TRIGGER”
FM AM Phono C D Tape
VCR
DVD Video 3 Video 2 Video 1
Setup
Push To Enter
DSP / Mode ADJ
DTR-5.2
Remote controller
Push To Enter
DSP / Mode ADJ
Setup
Push To Enter
DSP / Mode ADJ
Return
dB
12V Trigger
This setting allows you to make the required settings to turn on the
output from the 12V TRIGGER terminal to control another
component or device with the DTR-5.2 for each input source.
ON: Select to activate the device connected to the 12V TRIGGER
terminal when the input source is selected.
OFF: Select when no device is connected to the 12V TRIGGER
terminal or you do not want the connected device to activate.
1. Select the desired input source.
2. Press the Setup (SETUP) button.
Turn the jog dial or press the and cursor
buttons on the remote controller to display
“2. INPUT SETUP”
3. Press the jog dial or ENTER button
on the remote controller.
Turn the jog dial or press the cursor button
on the remote controller to display
“INTELLIVOLUME?”.
FM AM Phono C D Tape
VCR
DVD Video 3 Video 2 Video 1
4. Press the jog dial or ENTER button
on the remote controller.
The currently set volume level appears.
5. Turn the jog dial or press the and
cursor buttons on the remote
controller to set the IntelliVolume.
It can be adjusted between -12 and +12
decibels.
6. Press the Return (RETURN) button.
“INTELLIVOLUME?” appears in the front
display.
To exit the setup mode immediately, press
the Setup (SETUP) button.
DTR-5.2
Remote controller
Setup
Return
Push To Enter
DSP / Mode ADJ
Push To Enter
DSP / Mode ADJ
Push To Enter
DSP / Mode ADJ
Push To Enter
DSP / Mode ADJ
Push To Enter
DSP / Mode ADJ
Setup
4. Press the jog dial or ENTER button on
the remote controller.
The currently setting appears.
5. Turn the jog dial or press the and
cursor buttons on the remote
controller to set 12V TRIGGER.
6. Press the Return (RETURN) button.
“12V TRIGGER?” appears in the front
display.
To exit the setup mode immediately, press
the Setup (SETUP) button.
Push To Enter
DSP / Mode ADJ
Push To Enter
DSP / Mode ADJ