Invacare Spyder 1098318 - Manual (Page 17)

17
FRONT RIGGINGS PROCEDURE 3
Hex Screw/Coved Washer
Phillips Screw
Spacer
Locknut
FIGURE 8 - HEEL LOOP REPLACEMENT
HEEL LOOP REPLACEMENT
(FIGURE 8)
Composite Footplates
1. Remove the hex screw and coved washer that se-
cures the lower half of the footrest to the swingaway
footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the phillips screw and locknut that secure
the heel loop to the footrest.
4. Slide heel loop over slide tube of footrest assembly.
5. Replace heel loop.
6. Reverse preceding steps to reassemble.
NOTE: When securing the heel loop to the footrest as-
sembly, tighten the phillips screw and locknut until the
spacer is secure.
Adjustable Footplate
1. Remove the four (4) phillips screws and washers that
secure the existing heel loop to the footplate.
2. Position the mounting holes of the new heel loop with
the mounting holes in the adjustable footplate.
3. Secure the new heel loop to the footplate with the four
(4) phillips screws and washers.
Impact
Guards
Calf
Strap
FIGURE 7 - IMPACT GUARDS/OPTIONAL
CALF STRAP
Footrest Support
FRONT VIEW OF
FOOTPLATE AND
FOOTREST SUPPORT
Footplate
Perpendicular and/or Inversion/Eversion
Adjustment (FIGURES 4 AND 6)
NOTE: It is not necessary to remove the footplate to per-
form this adjustment.
1. Insert a flathead screwdriver through the half clamp
on the articulating footplate.
2. Slowly turn the nylon adjustment screw in or out until
the articulating footplate is perpendicular to the foot-
rest assembly or the desired inversion or eversion is
obtained.
IMPACT GUARDS/OPTIONAL CALF
STRAP (FIGURE 7)
1. Remove impact guard/calf strap from packaged con-
tainer if not already secured to the footrest.
2. Secure the impact guards to the footrest frame as
shown in FIGURE 7.
3. Secure the optional calf strap around the footrest
frame (with the impact guards attached).
COMPOSITE FOOTPLATES
Phillips Screw
Phillips Screw
Washer
Washer
ADJUSTABLE FOOTPLATES
FIGURE 6 - PERPENDICULAR AND/OR
INVERSION/EVERSION ADJUSTMENT
F
R
O
N
T
R
I
G
G
I
N
G
S