Infinity NV30K - Manual (Page 16)

15 www.infinityvac.com
English
fe
ff
g
h
i
k
j
Part Part No.
Motor Belt 1102-FP
Headlight Bulb 1088-FP
Foam and Felt Filters 1083-FP
HEPA Filter 1082-FP
Telescopic Wand 1121-FP
Detachable Handle 1119-FP
Super Stretch Hose 1120-FP
Upper Hose Holder 1086-FP
Crevice Tool 1084-FP
Upholstry/Dusting Brush
Pet Hair Power Brush 1097-FP
Low Reach Bare Floor Brush
To replace new Belt:
Slide one end of the new Belt over the
motor-driven shaft (
e ).
Slide second end of the Belt around
Brush Roll (
f ).
Partially insert the right end of the roller
into one side holder (
g ).
Partially insert the left end into the other
side holder (
h ).
Push both ends all the way into the side
holders at the same time.
Center Belt on motor-driven shaft; test
Brush Roll for easy turning.
Line up the 4 tabs on the Belt and Brush
Roll Cover with the slots on the Power
Nozzle (
i ); push into place.
Turn the three locking screws clockwise
(
j ) to tighten.
Cleaning the Pet Hair Power
Brush
Slide locking latch ( k ) forward.
Gently tilt brush housing upward to open.
IMPORTANT: DO NOT force; it will not
open all the way.
Remove debris from turbine wheel and air
passage.
Ordering Replacement Parts
To order additional parts and accessories,
go to www.infinityvac.com or call
1-888-668-9600.
Note: some parts may
be available at your local Infinity retailer.