Icom IC-M32 - Manual (Page 35)

29
10
TROUBLESHOOTING
9
10
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No sound from speaker. • Squelch level is too deep.
• Volume level is too low.
• Speaker has been exposed to water.
p. 10
p. 10
—
• Set squelch to the threshold point.
• Push [+]/[–] to set a suitable level.
• Drain water from the speaker.
The transceiver does
not turn ON. • The battery is exhausted.
• Bad connection to the battery pack. p. 23
p. 3 • Recharge the battery pack.
• Check the connection to the transceiver.
Transmitting is impossi-
ble, or high power can
not be selected. • Some channels are for low power or re-
ceive only.
• The battery is exhausted.
• The battery over charged.
• The output power is set to low.
pgs. 8,
9, 30
p. 23
—
p. 11
• Change channels.
• Recharge the battery pack.
• Verify the battery voltage is correct.
• Push [H/L•
LOCK ] to select high power.
The displayed channel
cannot be changed. • Lock function is activated. • Push [H/L• LOCK ] for 1 sec. to cancel the
function.
p. 13
Scan does not start. • “TAG” channels are not programmed. • Set the desired channels as “TAG” channels. p. 15
No beeps. • Beep tones are turned OFF. • Set the beep tones to ON (Fix Beep/User
Beep) in SET mode.
p. 18
Self check error.
(Temperature) • The temperature is outside of –25°C to
+65°C; –13°F to +149°F (approx)
• Leave the transceiver at room temperature
for a while. Turn the power ON to check if the
internal temperature has returned to normal.
Self check error.
(Battery voltage) • The connected battery pack’s voltage is
more than 11 V.
• Verify the battery voltage is correct.
—
—
Self check error.
(Water intrusion) • Water has entered the transceiver. • Have the transceiver checked at your local
distributor or dealer to see whether the trans-
ceiver works properly or not.
—
IC-M32-1.qxd 03.9.25 6:21 PM Page 29 (1,1)