Innovative Office Products LCD Monitor Arm 9103 - Manual

LCD Monitor Arm
Model No. 9103
INSTRUCTIONS
The IOP Monitor Arm Model 9103 comes in three parts.
Each component is sold separately.
1. Mount assembly (instructions enclosed separately)
2. Monitor Arm assembly
3. Adapter Bracket
The Monitor Arm is easily assembled following these simple
steps.
Be sure the mount is securely fastened to the surface
before beginning.
Step 1 Attaching the Arm to the Mount
Once the mount is secure, insert the shaft of the LCD Arm into the
mount as shown below in Illustration 1 (Mounts will vary).
Illustration 1
Step 2 Attaching the Tilter to the Adapter Bracket
Carefully remove the base from the flat panel monitor. For removal
instructions, see your Flat Panel User’s Guide.
If the adapter bracket is already attached to the tilt mechanism,
skip this step and continue with step 3.
If the adapter bracket is not attached to the tilt mechanism, attach it
using the (4) 1/4-20 x 1/2 Philips Pan Head Screws as shown
below in Illustration 2.
Illustration 2
Step 3 Attaching the Adapter Bracket to the Flat Panel
Align the tilter and adapter bracket with the hole pattern on the
back of your LCD. Use the (4) four M4-12 Philips Pan Head
Screws to attach the plate to the back of the monitor. See the
lllustration 3 below.
NOTE: If the bracket does not line up with the hole
pattern on the back of your monitor, please
contact our customer service department.
Slide the titler shaft into the hole in the end of the forearm, as
shown in Illustration 4 below.
Illustration 4
Fine Tuning Your Arm
Adapter Bracket
Tilt
Mechanism
Arm
Assembly
Illustration 3
Forearm
1/4-20 x 1/2
Screws
Step 1 Adjusting the Tilt Friction
Tilt the monitor to the preferred angle of viewing and tighten the
Friction Knob.
Friction Knob
Be sure the LCD tilts with resistance.
Not enough friction may cause
the monitor to fall forward
without stopping, possibly
damaging your monitor.
Tilter Shaft