IFB Appliances ELENA User Manual

Page 6

1. MAKE SURE THAT THE MACHINE RESTS ON ALL

FOUR FEET ON A LEVEL SURFACE.Adjustable

screws are provided at the bottom to allow

levelling.

2. Loosen securing nut. Adjust the screw to change

level. Tighten securing nut to ensure that screw is

locked into place.

3. MACHINE SHOULD BE LEVELLED AGAIN IN C A S E

IT IS MOVED TO A NEW SITE.

1. A drain pump is provided in the machine to pump out

used water.

2. The end of the outlet should be placed near a drain. If

necessary, it can be placed over the edge of a sink

at a maximum height of 1 mt. from the floor level.

3. Allow free flow of water from the outlet pipe.

1. Check that the electrical line can take the required

load.

2. Connect to a 220V, 50 Hz single phase AC supply.

3. Machine must be earthed properly before

operation. This can be done by using a 3 pin plug

and properly earthed socket of 16 ampere rating.

4. Ensure that there is a firm connection between the 3

pin plug and socket, else it may result in sparking and

subsequent failure of 3 pin plug.

5. Use of extension cord not recommended.

SETTING UP

1. Connect inlet hose to water tap/line.

2. Do not connect machine to a hot water supply.

WATER INLET

WATER OUTLET

ELECTRICAL CONNECTION

16 AMPS

WATER INLET

DRAIN

PIPE

WATER INLET

DRAIN

PIPE